OPTIFLUX 2100

Electromagnetic flowmeter for all standard water and wastewater applications

  • Chemically resistant liner materials
  • Compact version up to IP69, remote version IP68
  • Flange: DN25…1200 / 1…48", max. PN40 / ASME Cl 300
  • 4…20 mA, pulse, frequency, status, HART®

OPTIFLUX 2100

Electromagnetic flowmeter for all standard water and wastewater applications

  • Chemically resistant liner materials
  • Compact version up to IP69, remote version IP68
  • Flange: DN25…1200 / 1…48", max. PN40 / ASME Cl 300
  • 4…20 mA, pulse, frequency, status, HART®

Overview

The OPTIFLUX 2100 is an electromagnetic flowmeter (EMF) for standard water and wastewater applications. It is the ideal solution for all general flow applications where reliable flow measurement with sufficient yet not extremely high accuracy is required. Installation in measurement chambers subject to (constant) flooding is possible with the remote IP68 / NEMA 6P rated version.

Product features and options depend on device configuration: Contact us to make sure that your preferred functionality can be combined in one device.

  • Bi-directional flow measurement over a wide dynamic range
  • Optional for subsoil installation and constant flooding
  • Proven and unsurpassed life time, huge installed base
  • Standard wet calibration
  • PP or hard rubber liner: suitable for low concentrated chemicals
  • Tamper proof
  • Standard measurement accuracy: ±0.3% or ±1mm/s of measured value (MV)
  • Diagnostics incl. conductivity, electrode error, ambient and process temperature etc.
  • Full bore design: No moving parts, no wear, no pressure loss
  • Meets potable water standards: ACS, DVGW, NSF, TZW, WRAS etc.
  • For hazardous areas: ATEX, IECEx, FM, CSA
  • On-site verification of flowmeter with OPTICHECK service tool

Related products

IFC 100

Electromagnetic flow converter for combination with OPTIFLUX and WATERFLUX flow sensors

  • Compact and wall-mounted housing
  • With many sensor and process diagnostics for standard requirements
  • 4-wire, 4…20 mA, pulse, frequency, status, HART®

OPTIFLUX 2000

Electromagnetic flow sensor for combination with IFC 050, IFC 100 and IFC 300 signal converters

  • Full bore design: pipe cross-section without restrictions
  • Connection sizes: DN25…1200 / 1…48"
  • Liner: PP, PO or hard rubber
Email
Contact